5.3 Cork-Neoprene


Cork-neoprene mixture (called coroprene) can also be used; however, it does not perform as well as cork-nitrile. This material takes a set when it is compressed and should only be used when there are no expansion limiting grooves. Using cork-neoprene in grooves can result in leaks from expansion and contraction of mating surfaces. The material is very porous and should be sealed on both sides and edges with a thin coat of Glyptol No. 1201B red or similar sealer before installation. Glyptol No. 1201B is a slow drying paint used to seal metal flanges and gaskets, and the paint should be allowed to dry totally before installation. Once compressed, this gasket should never be reused. These gaskets should be kept above 35 ºF before installation to prevent them from becoming hard. Gaskets should be cut and sealed (painted) indoors at temperatures above 70 ºF for ease of handling and to reduce paint curing time. Avoid installing corkneoprene
gaskets when temperatures are at or near freezing because the gasket could be damaged and leak. Cork-neoprene gaskets must be evenly compressed at about 43 to 45%. For example, if the gasket is ¼-inch thick, 0.43 x 0.25 = 0.10. When the gasket is torqued down, it should be compressed about 0.10 inch. Or you may subtract 0.1 from ¼ inch to calculate the thickness of the gasket after it is compressed.

In this case, ¼ = 0.25 so 0.25 minus 0.10 = 0.15 inch would be the final distance between the mating surfaces after the gasket is compressed. In an emergency, if compression limits are required on this gasket, split lock washers may be used. Bend the washers until they are flat and install enough of them (minimum of three), evenly spaced, in the center of the gasket cross section to prevent excessive compression. The thickness of the washers should be such that the gasket compression is limited to approximately 43%, as explained above.

обновлено: September 29, 2016 автором: dannik