GlobeCore’s US-6S power transformers vacuum drying oven at electric power plants is a great piece of kit. It is specially designed for drying transformer windings before they are put into operation or after repairs. The unit makes sure that moisture is completely removed, which is really important for transformers that are used in power plants and substations. The power supply in these places depends on them being reliable. If moisture builds up in the transformer windings, it can reduce the electrical insulation a lot, and this can cause short circuits or equipment failure. The US-6S makes a vacuum in the drying chamber, so that moisture evaporates even from hard-to-reach areas without damaging the insulating materials. The unit has a vacuum chamber that is sealed so that no air can get in or out. It also has a pump that is very powerful and a system that automatically controls the temperature and the pressure. This makes sure everything dries evenly and safely. GlobeCore’s US-6S is a reliable solution for the power industry. It helps to extend the life of transformers and ensure that power plants operate stably.

Power transformers vacuum drying oven at electric power plants US-6S Specifications

No.	Parameter	Value
	Drying chamber
1	Internal dimensions, mm, max
	– depth	2,000
	– width	1,300
	– height	1,600
	Heating section
2	Heater power, kW	45
3	Temperature adjustment range, °С	20…120
4	Quantity of thermal electric heaters, pcs	15
	Vacuum section
5	Capacity, m³/h	1,000
6	Total power level of engines, kW	11
7	Achieved vacuum level, mbar	1
	Circulation system
8	Capacity, m³/h	2,000
9	Fan power, kW	2.2
	Exhaust system
10	Capacity, m³/h	2,000
11	Fan power, kW	1.1
	Condensation system
12	Chiller power, kW	3.0
13	Cooling performance of chiller, kcal/h	6,000
14	Condensation area, m²	7.5
15	Heat exchanger (condenser) type	shell-and-tube
	Pneumatic system
16	Compressor power, kW	1.1
17	Pressure, bar	9