Inline Oil Heater PPM. Stream oil heating

Inline Oil Heater PPM-18 for Dielectric Oil Heating at Electricity substation

The PPM oil heating unit is designed for the heating of transformer oil when: (1) adding oil to transformers; (2) replacing transformer oil; and (3) when drying transformers. Additionally, the unit can heat mineral oils, industrial oils, turbine oils and other types of oils as well as non-corrosive liquids.

This oil heating unit is best suited to power plants, oil handling facilities, and facilities that perform transformer repairs and maintenance. The unit can be operated either indoors or outdoors under a suitable canopy.

Aforementioned oils and liquids should be of less than 70 cSt kinematical viscosity at the temperature of 50°C. Oil Heater CMM-P is also used for heating of petroleum products in the petroleum refining industry, and can also be used for heating liquids of high muddiness rate (sand, slime, etc.)

 

Parameter

Oil Heater Values
PPM-18 PPM-50 PPM-70
Throughput at inlet line pressure 0.2 MPa, m3/ hour, max  

2.2

   
Throughput at inlet line pressure 0.24 MPa/cm2, m3/hour, max 1,2 4
Fluid pressure, MPa, max 0.6 4 2.5
Nominal power, kW 19.5 56 74
Power supply at ~ 50 Hz, V (60Hz upon request) 380/220 380 380
Max heating temperature, oС/ oF 120/248 150/302*  
Dimensions, mm/ft, max
• length 800/2’8” 1180/3’11” 1220/4’
• width 660//2’2” 800/2’8” 820/2’8”
• height 1830//6’ 1870/6’2” 1900/6’3”
Weight, kg/lbs, max 180/397.8 400/884 500/1,105

* Max heating temperature may be increased up to 200°С/ 392°F on customer request

обновлено: May 25, 2017 автором: dannik