For a start-up making formulations that combine bitumen, kerosene, acids and amines you’ll want a compact, process-safe plant built around heated mixing vessels plus high‑shear homogenization and accurate dosing. Typical equipment includes insulated, steam- or electrically-heated stainless steel tanks with anchor agitators for low‑shear bulk blending and a rotor–stator disperser or colloid mill/inline high‑pressure homogenizer to produce stable emulsions and fine dispersions. Metering pumps for kerosene and liquid additives, pH and temperature probes, bag/inline filtration and vapor recovery or condensation for solvent control are essential for consistent product quality and environmental compliance.

Material compatibility and safety drive design choices: use 316L stainless for most components, PTFE or rubber linings and corrosion‑resistant alloys (or special coatings) where strong acids are handled, and select seals and pump materials rated for hydrocarbons and amines. Sequence and controls matter: heat bitumen to lower viscosity, add kerosene slowly under agitation, dose acid/amine and emulsifier with closed‑loop pH control, then pass the blend through the homogenizer to achieve target droplet size and viscosity. Monitor viscosity, softening point/penetration (for bituminous products), particle size and pH as your QC checks, and install ATEX‑rated motors, grounding and adequate ventilation because kerosene is flammable. If you want, tell me target batch size, throughput and whether you’ll produce cationic or anionic emulsions and I’ll suggest specific GlobeCore modules and a basic plant layout that fits your formulations and safety requirements.

The TOR-1 moisture meter manual can be provided in printable format. It includes calibration and operational guidelines.

Thank you for your interest. GlobeCore can supply a complete transformer maintenance set including oil purification (CMM-6RL), vacuum drying, oil testing (TOR series), and degassing equipment. Please provide estimated transformer capacities and required throughput to prepare a comprehensive quotation.

While India has local manufacturers, GlobeCore exports CE-certified transformer oil filtration machines to India, offering higher precision, European components, and long service life. Support and training are available via partners in Delhi and Mumbai.

Contractors prefer GlobeCore’s mobile oil filtration machines – compact, trailer-ready, and compliant with high-voltage safety standards. These units handle 600-6000 L/h and support quick deployment for on-site transformer oil cleaning and filling operations.

“Oil turbine” typically refers to lubricating fluids for gas and steam turbines that cool, lubricate, and prevent corrosion. GlobeCore purification plants degas and filter turbine oils, extending their lifespan and protecting equipment.

Nytro Taurus is a premium inhibited mineral oil with excellent oxidation stability, ideal for large power transformers. GlobeCore purification plants restore Nytro Taurus oils, keeping their dielectric properties intact over years of service.

The Danfoss 052F4030 is an oil-filled component used in industrial systems, relying on clean dielectric oil for reliable operation. GlobeCore filtration plants maintain the oil’s dielectric properties by removing moisture and impurities.

The GlobeCore TOR-8 uses vacuum extraction to quickly and precisely measure dissolved gases, providing diagnostic results in a single cycle on-site.

Soybean-based biodiesel has an energy efficiency of about 93% compared to fossil diesel, meaning most of its energy content is retained after processing. It produces similar power output in diesel engines and can even improve lubrication, reducing engine wear. While its energy density is slightly lower than fossil fuels, it compensates with renewable sourcing and lower emissions. The GlobeCore USB system enhances efficiency by reducing feedstock loss during production and ensuring complete chemical conversion, resulting in high-quality fuel with optimal energy performance.