GlobeCore / Produk / Zeolite Processing / BRPS Zeolite Regeneration Block

BRPS Zeolite Regeneration Block

BRPS

BRPS plant is designed to clean the sorbent (zeolite) from oil residues using overheated steam and to remove previously absorbed...
    Advantages
    • compact size;
    • mobility due to wheel-mounted design;
    • the heater power is sufficient to heat the air up to 400 °C, thus, BRPS can be used to solve other problems requiring a higher heating temperature;
    • zeolite saving due to reusing it to dry the oils.
Request Price

BRPS plant is designed to clean the sorbent (zeolite) from oil residues using overheated steam and to remove previously absorbed moisture by drying with hot air.

The block is used in power-producing, industrial, and other divisions that apply zeolite-filled adsorbers to dry lubricating and electrical insulating oils, such as CMM-260C transformer dry-out system.

Principle of operation

In order to reclaim the absorbing properties of zeolite, it must be warmed up to 250 °C. But zeolite contains oil residues the flash point of which is usually much lower, e.g. 130 °C for transformer oil.

Therefore, prior to heating, the plant removes oil residues by cleaning the zeolite layer with overheated steam created by a steam generator. The cleaning products are collected in an auxiliary tank.

After removing the oil residues, zeolite is dried with hot air supplied by a blower to the heater and having the temperature of 250 °C at the heater outlet.

At the final stage, zeolite-filled equipment is vacuumized due to the operation of a vacuum pump which pumps out the remaining steam and steam-gas mixtures.

After zeolite cools down, it is ready to be reused for drying industrial oils.

№

Parameter

Value
1 Parameters for steam cleaning mode  
 

– steam temperature, 0 °C

150
 

– pressure, MPa

0,5
 

– heaters power, kW

12
2

Parameters for drying mode

  
 

– air blower capacity, m3/min, not less than

2,3
 

– heated air temperature, ºС

150-250
3

Parameters for vacuumizing mode

– evacuation rate, L/s, not less than

6,6
– residual pressure, mbar (mPa),

not more than

2,5 (250)
4

Air blower power, kW, not more than

10,8
5

Power of cooling device impeller drive, kW, not more than

0,75
6

Required power, kW, not more than

13,2
7

Dimensions, mm, not more than:

– length

1100

– width

650

– height

1350
8

Weight, kg, not more than

210

  • compact size;
  • mobility due to wheel-mounted design;
  • the heater power is sufficient to heat the air up to 400 °C, thus, BRPS can be used to solve other problems requiring a higher heating temperature;
  • zeolite saving due to reusing it to dry the oils.

Loading...