CLM-0.25.1 Laboratory colloid mill
CLM-0.25.1 Laboratory colloid mill
CLM-0.25.1 colloid mill is designed for homogenization and emulsification of liquid materials (thick slurries of high shear stresses) in a laboratory environment.
CLM-0.25.1 can be used:
- to prepare laboratory batches of bitumen emulsions;
- to select the formulation of bitumen emulsion depending on its set of ingredients and field of application.
This colloid mill can be supplied as part of USB-2 bitumen emulsion production units, or as a separate product.
Bitumen emulsions — Fields of application
- Road construction:
- surfacing emulsions;
- pothole patching;
- bonding of asphalt layers;
- using in Slurry Seal and Multimac technologies;
- ground and base stabilization;
- emulsions intended for reuse of asphalt materials (recycling);
- long-term storage emulsions (wintertime pothole patching mixtures);
- tackiness remover emulsions.
- Hydraulic engineering facilities:
- emulsions intended to arrange waterproof membranes for foundations, swimming pools, pipe and pile linings, etc.;
- emulsions are applied to the surface by jet method, single- or double-component method (to accelerate film formation).
- Roofing:
- emulsions intended to obtain waterproof membranes on the surface of roofs of various complexity. These emulsions are applied to the surface by jet method.
| № | Parameter | Value |
| 1 | Capacity, L/h (gpm), (min) |
25 (0.11)* |
| 2 | Fill funnel volume, L (gal) |
1.5 (0.4) |
| 3 | Operating temperature, °C (°F), (max) |
150 (302) |
| 4 | Knife axial gap, mm (in) |
0.25… 1.25 (9.8∙10-3… 4.9∙10-2) |
| 5 | Knife radial gap, mm (in) |
0.25 (9.8∙10-3) |
| 6 | Knife tip speed, m/s (ips) |
50-57 (1,968.5-2,244)** |
| 7 | Rotation speed of mill shaft and electric drive, rpm |
16,750-19,250** |
| 8 | Rated power of electric drive, kW |
0.7 |
| 9 | Power circuit voltage at 50 Hz (three-phase), V |
400*** |
| 10 | Dimensions in operational position, mm (in), (max) | |
| — length |
340 (13)/425 (17) |
|
| — width |
290 (11) |
|
| — height |
450 (18) |
|
| 11 | Weight, kg (lbs), (max) |
15 (33) |
* Depending on the product viscosity
** Depending on installation of frequency converter
*** As requested by the customer
- capacity adjustment;
- corrosion resistance;
- compactness;
- selection of the optimal ratio of asphalt emulsion components (recipes);
- preparation of bitumen emulsion samples for further testing.
- any type of materials for asphalt emulsion production can be tested in this mill because the mill can be equipped with various rotor/stator tooling, depending on the material and the required process.
No publications found.
