GC engineers have just developed and constructed a new degassing plant CMM-6D

Breaking news!
Our engineers have just developed and constructed a new degassing plant, the CMM-6D, which has been successfully tested and put into production.

DEGASSING UNIT CMM-6D

Degassing unit CMM-6D has been designed to clean electrical and turbine oils by removing mechanical impurities as well as water and gases using a thermal vacuum purification process.

The main features of this degassing unit are:

1. Automatic Touch Pad Controls

2. Using only one oil pump
3. Operation is controlled automatically
4. Energy saving equipment: oil is heated according to pre-set performance standards
5. Vacuuming of many other types of equipment

The purifier operates in the following modes:

• «out vacuum mode»
• «heating filtration mode»
• «vacuum mode»
• «degassing mode»
• «manual mode»

Parameters:
1 Capacity, м3/hour

• degassing, drying and filtration mode 2-6
• heating and filtration mode 2-6

2* Properties of purified oil:

• volumetric gas content % 0.5
• volumetric water content, ppm, не более 5.0
• filtration fineness, microns 1

3.Size and mass, mm

• length 3700
• width 1750
• height 2320

4. Mass, kg 2600

Oil reclamation equipment will extend life of your transformers and safe your money.